|
The following check list will tell you if your home has been properly wired for a burglar alarm by your builder. If there are wires missing or left in the attic which cause us additional work to rectify we may charge extra.
Cables hanging on windows and doors in brown or white. If a window has more than 1 opening then a wire should go to each opening. The wire should be at the place where the window opens.
In the case of windows which open from the bottom then the wire should be at the bottom.
In the case of velux the cable should be on the lowest part of the window not the top!.
Cable situated in entrance hall for keypad.
Cable hanging out, up high at front or side of house for alarm bell/siren within reach of standard ladder.
If you require a motion detector in a room, then there should be a cable installed by builder near ceiling in that room. You should have 1 motion detector in the hallway.
All of of the above cables returning to a central point usually beside the electrical fuse board. Builder should have also wired in power supply for alarm.
|
